Help / Alerts
Email alerts
An email channel sends alerts to one inbox. It is the simplest channel to set up and a good backup for any other channel you use.
What you need first
- The email address that should get the alerts. It can be your own, a colleague's or a shared team inbox.
- A confirmed account. Until you confirm your own email address with the link we sent when you signed up, alerts can only go to that address.
Set it up
- Open Alerts and go to Add a channel.
- Under Where should alerts go?, choose Email.
- In Send to, type the email address.
- If you like, fill in Label (optional), such as "Support inbox".
- Tick the events this address should get: Down, Back up, Certificate expiring and Slow.
- Press Add channel.
The address does not need to be confirmed by its owner. Alerts start straight away, so check you typed it correctly.
One channel sends to one address. To alert several people, add a channel for each address, or use a shared inbox or mailing list.
Send a test
- In the channel list on Alerts, press Send test on the email row.
- Check the inbox. The subject ends with "Test monitor test alert".
- If nothing arrives within a few minutes, look at Recently sent at the bottom of the Alerts page.
What an alert email looks like
The subject starts with the service name in square brackets, then the monitor name and what happened, for example "Shop is DOWN" or "Shop is back UP". The email gives the monitor's address, the reason (such as the status code or a timeout) and a link to the monitor's page.
If it does not work
- Recently sent shows failed. Our mail server could not send it. The reason is shown next to it. Send another test in a few minutes, and contact us if it keeps failing.
- Recently sent shows sent, but nothing arrived. Look in the spam or junk folder, and in any other tabs or folders your mail app sorts mail into. If you find it there, mark it as not spam and add the sender to your contacts so later alerts land in the inbox.
- A work address gets nothing. Some company mail systems hold or drop automated mail. Ask your IT team to allow mail from the address the test came from.
- The address was wrong. A channel cannot be edited. Add a new email channel with the right address, test it, then press Remove on the old one.
- You see "Confirm your email address first". Open the confirmation link we emailed you when you signed up. Until then you can only add your own address.
For other reasons an alert might not go out at all, see Setting up alerts and I did not get an alert.
Still stuck? Email [email protected] and say which guide you were following.