Help / Monitors
Domain expiry monitor
A domain expiry monitor warns you before a domain registration runs out, so a missed renewal does not take your website and email offline.
What you need first
- The registered domain name, such as
example.comorexample.co.za. Use the domain you pay a registrar for, not a subdomain likewww.example.com.
Set it up
- Open Monitors and press Add monitor.
- Choose Domain expiry.
- In Domain, type the domain name. If you paste an address with
https://or a path, only the name is used. - In Alert this many days before it expires, choose how much warning you want. The default is 30 days. You can choose from 1 to 365.
- Give it a Friendly name.
- Look over Where alerts go and press Start monitoring.
You will see a Check every list on the form, but domain monitors are checked every 6 hours whatever you choose. Registries limit how often they can be asked, and expiry dates change slowly.
How it works
The check asks the domain's registry for its record over RDAP, the newer replacement for WHOIS. From the answer it reads the expiry date and the registrar. One checking location does each lookup.
When fewer days are left than your setting, the check fails. The monitor goes down, an incident opens, and a down alert goes out with the reason, for example "Domain expires in 21 days". Make sure your alert channels have Down ticked on the Alerts page. Once the domain is renewed and the new date shows up at the registry, the next check brings the monitor back up.
The monitor page shows the days left, the expiry date and the registrar.
Renewing at the registrar can take a while to reach the registry's record. If you renewed and the monitor still says down, give it a few hours: it checks again every 6 hours.
Send a test
Open Alerts and press Send test on each channel. Then open the monitor. After the first lookup it should show the days left and the registrar.
When it does not work
- "Domain not registered or registry has no RDAP". Either the name is not registered (check the spelling, and that you did not type a subdomain), or the registry for that ending does not offer RDAP. Some country-code registries do not. In that case this monitor cannot watch the domain, and you will need to keep track of the date another way.
- "Not a domain name". The name has characters a domain cannot have, or no ending such as
.com. - "Registry does not publish an expiry date". The registry answered but gave no date. The monitor stays up, but it cannot warn you.
- An error that starts "RDAP lookup failed", or "Timed out". The registry did not answer properly or in time. One failed lookup is enough to count as down, so you may get a down alert for it. It clears when a later lookup works.
Still stuck? Email [email protected] and say which guide you were following.